![]() converter, but it goes out now and then, and it starts hard even when the CEL is off. It does have a CEL that references a bad cat. ![]() for your car alarm remote starter or keyless entry installation into your. The timing light tells me all four plugs are getting juice and the pattern is consistent. Mazda Protg and Cars 1990-1998 and Ford Probe 1993-1997 Wiring Diagrams. In addition when it does start after this hard staring issue, it runs very rough for a few miles.Ĭompression is good on all four cylinders Then it seems to start and run just fine. The only time it starts is if it was driven within the past few hours. After 10-15 minutes of cranking, I can sometimes get it to start. I have had the car for 7 months and it has become harder and harder to start over that time. If your car still won't start, you should consult with a professional from YourMechanic to determine if there is another issue that is preventing your car from starting.OK, I have a '97 Protege 1.5 with 120K miles. Remove the key and try to start the engine.īe sure to leave the key cylinder in the unlocked position.Īn anti-theft system that prevents your car from running properly is a nuisance, and while you may be thankful for it in the event of a crime, it is now causing you a great deal of inconvenience, which these steps have hopefully helped you resolve. Tip: Try turning the key both ways fully to disable the anti-theft system.Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Hold the key in this position for 20 to 30 seconds. Turn the key to unlock your car door, but don’t release it. Use the driver’s side door and the physical key even if your vehicle is equipped with a keyless entry system. Step 1: Insert your key in the lock on the door. Method 3 of 3: Use the key in your car door Try the process over again to see if it will work. If it still won’t start, check to make sure the battery hasn’t been drained. This gives the system time to reset or you won’t be able to start your car. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two. Step 3: Check the anti-theft light again. Leave the key in position for about 10 – 15 minutes. Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Step 2: Turn the ignition to the "on" position. It’s located on your dash and will have a blue or red light. You’ll have to disable it with these steps. If the anti-theft system has locked up your engine, you won’t be able to start it. ![]() The key you are using may not have the chip required to start your car. “Valet” keys are often distinguished by a “V” on the key shaft or a different-colored key head. Many cars have a “valet” key or a door key that only performs certain functions such as unlocking the doors. Step 3: Check that you are using the proper key to start your car.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |